MeshCollapseFacesByEdgeLength Method |
Collapses multiple mesh faces, with greater/less than edge length, based on the principles
found in Stan Melax's mesh reduction PDF,
see http://pomax.nihongoresources.com/downloads/PolygonReduction.pdf
Namespace:
Rhino.Geometry
Assembly:
RhinoCommon (in RhinoCommon.dll)
Since: 6.0
Syntax public int CollapseFacesByEdgeLength(
bool bGreaterThan,
double edgeLength
)
Public Function CollapseFacesByEdgeLength (
bGreaterThan As Boolean,
edgeLength As Double
) As Integer
Parameters
- bGreaterThan
- Type: SystemBoolean
Determines whether edge with lengths greater than or less than edgeLength are collapsed. - edgeLength
- Type: SystemDouble
Length with which to compare to edge lengths.
Return Value
Type:
Int32Number of edges (faces) that were collapsed, -1 for general failure (like bad topology or index out of range)
or -2 if all of the edges would be collapsed and the resulting mesh would be invalid.
Remarks
This number may differ from the initial number of edges that meet
the input criteria because the lengths of some initial edges may be altered as other edges are collapsed.
See Also