CurveCreateInterpolatedCurve Method (IEnumerablePoint3d, Int32, CurveKnotStyle)

Interpolates a sequence of points. Used by InterpCurve Command This routine works best when degree=3.

Namespace: Rhino.Geometry
Assembly: RhinoCommon (in RhinoCommon.dll)

Since: 5.0

Syntax

public static Curve CreateInterpolatedCurve(
	IEnumerable<Point3d> points,
	int degree,
	CurveKnotStyle knots
)

Public Shared Function CreateInterpolatedCurve ( 
	points As IEnumerable(Of Point3d),
	degree As Integer,
	knots As CurveKnotStyle
) As Curve

points: Type: System.Collections.GenericIEnumerablePoint3d
Points to interpolate. For periodic curves if the final point is a duplicate of the initial point it is ignored. (Count must be >=2)
degree: Type: SystemInt32
The degree of the curve >=1. Note: Even degree > 3 periodic interpolation results in a non-periodic closed curve.
knots: Type: Rhino.GeometryCurveKnotStyle
Knot-style to use and specifies if the curve should be periodic.

Type: Curve
interpolated curve on success. null on failure.

CurveAddLanguageSpecificTextSet("LSTF340B7C0_0?cpp=::|nu=.");CreateInterpolatedCurve Method (IEnumerableAddLanguageSpecificTextSet("LSTF340B7C0_1?cs=&lt;|vb=(Of |cpp=&lt;|fs=&lt;'|nu=(");Point3dAddLanguageSpecificTextSet("LSTF340B7C0_2?cs=&gt;|vb=)|cpp=&gt;|fs=&gt;|nu=)");, Int32, CurveKnotStyle)