NurbsCurveCreateHSpline Method (IEnumerablePoint3d, Vector3d, Vector3d)

Construct an H-spline from a sequence of interpolation points and optional start and end derivative information

Namespace: Rhino.Geometry
Assembly: RhinoCommon (in RhinoCommon.dll)

Since: 7.0

Syntax

public static NurbsCurve CreateHSpline(
	IEnumerable<Point3d> points,
	Vector3d startTangent,
	Vector3d endTangent
)

Public Shared Function CreateHSpline ( 
	points As IEnumerable(Of Point3d),
	startTangent As Vector3d,
	endTangent As Vector3d
) As NurbsCurve

points: Type: System.Collections.GenericIEnumerablePoint3d
Points to interpolate
startTangent: Type: Rhino.GeometryVector3d
Unit tangent vector or Unset
endTangent: Type: Rhino.GeometryVector3d
Unit tangent vector or Unset

Type: NurbsCurve
NURBS curve approximation of an arc on success

NurbsCurveAddLanguageSpecificTextSet("LST2A051E11_0?cpp=::|nu=.");CreateHSpline Method (IEnumerableAddLanguageSpecificTextSet("LST2A051E11_1?cs=&lt;|vb=(Of |cpp=&lt;|fs=&lt;'|nu=(");Point3dAddLanguageSpecificTextSet("LST2A051E11_2?cs=&gt;|vb=)|cpp=&gt;|fs=&gt;|nu=)");, Vector3d, Vector3d)