ModelAidSettings Properties |
The ModelAidSettings type exposes the following members.
Properties| Name | Description | |
|---|---|---|
  | AltPlusArrow | true means Alt+arrow is used for nudging. |
| AutoAlignCPlane |
Gets or sets whether the cplane will automatically align to the selection
|
| AutoCPlaneAlignment |
//0 = object, 1 = world, 2 = view
|
| AutoGumballEnabled |
When AutoGumball is on, a gumball automatically appears
when objects are pre-picked.
|
| ControlPolygonDisplayDensity | Gets or sets the control polygon display density. |
| CtrlNudgeKeyStep | Gets or sets the Ctrl-key based nudge step amount. |
| DisplayControlPolygon | Gets or sets the enabled state of Rhino's display control polygon. |
| ExtendToApparentIntersection | Gets or sets the enabled state of Rhino's extend to apparent intersections. |
| ExtendTrimLines | Gets or sets the enabled state of Rhino's extend trim lines. |
| GridSnap | Gets or sets the enabled state of Rhino's grid snap modeling aid. |
| GumballAutoReset |
When GumballAutoReset is on the gumball resets its orientation after a drag
When GumballAutoReset is off the gumball orientation is kept to where it was dragged
|
| GumballExtrudeMergeFaces |
When ExtrudeMergeFaces is true the gumball will attempt to merge
faces if possible after extruding a face
|
| HighlightControlPolygon | Gets or sets the enabled state of Rhino's highlight dialog modeling aid. |
| MousePickboxRadius | radius of mouse pick box in pixels. |
| NudgeKeyStep | Gets or sets the nudge step amount. |
| NudgeMode | 0 = world, 1 = cplane, 2 = view, 3 = UVN, -1 = not set. |
| OnlySnapToSelected | |
| OrientAutoCPlaneToView |
Gets or sets whether the auto cplane will rotate towards the view after aligning to the selection
|
 | Ortho | Gets or sets the enabled state of Rhino's ortho modeling aid. |
| OrthoAngle | Gets or sets the base orthogonal angle. |
| OrthoUseZ |
Gets or sets whether Ortho will snap to the CPlane Z axis
|
| Osnap | Enables or disables Rhino's object snap modeling aid. |
| OsnapCursorMode | Gets or sets the OSnap cursor mode. |
| OsnapModes |
Returns or sets Rhino's current object snap mode.
The mode is a bitwise value based on the OsnapModes enumeration.
|
| OsnapPickboxRadius | Enables or disables Rhino's planar modeling aid. |
| Planar | Gets or sets the enabled state of Rhino's Planar modeling aid. |
| PointDisplay | Gets or sets the point display mode. |
| ProjectSnapToCPlane | Gets or sets the enabled state of Rhino's Project modeling aid. |
| ShiftNudgeKeyStep | Gets or sets the Shift-key based nudge step amount. |
| SnappyGumballEnabled |
When SnappyGumball is on, a dragging a gumball moves the center point.
When snappy gumball is off, dragging a gumball moves the mouse down point.
|
| SnapToFiltered | |
| SnapToLocked | Gets or sets the locked state of the snap modeling aid. |
| SnapToOccluded | |
| StickyAutoCPlane |
Gets or set whether the auto cplane will stay even after deselection
|
| UniversalConstructionPlaneMode | Gets or sets the locked state of the snap modeling aid. |
| UseHorizontalDialog | Gets or sets the enabled state of Rhino's use horizontal dialog modeling aid. |
See Also