QuadRemeshParametersTargetEdgeLength Property |
When TargetEdgeLength is greater than 0 TargetQuadCount will be re-computed with
the target goal of an approximated edge length based on the area of the input mesh
e.g TargetQuadCount = Input mesh Area * sqr(TargetEdgeLength)
AdaptiveSize as well as AdaptiveQuadCount will also be ignored;
Namespace:
Rhino.Geometry
Assembly:
RhinoCommon (in RhinoCommon.dll)
Since: 7.8
Syntax public double TargetEdgeLength { get; set; }
Public Property TargetEdgeLength As Double
Get
Set
Property Value
Type:
DoubleSee Also